D-Link DAP-3320 Quick Install Manual
Wireless poe outdoor access point
Hide thumbs
Also See for DAP-3320:
- User manual (139 pages) ,
- Quick installation manual (33 pages) ,
- Quick installation manual (21 pages)
Table of Contents
Advertisement
Quick Links
Download this manual
See also:
User Manual
Advertisement
Table of Contents
Related Manuals for D-Link DAP-3320
Summary of Contents for D-Link DAP-3320
-
Page 2: Package Contents
• Internet Explorer 8, Chrome, Firefox, or Safari 5.1 or higher Note: To power the unit, use a D-Link PoE switch or the D-Link DPE-301GI PoE injector (not included). * Maximum Wireless signal rate derived from IEEE 802.11n and 802.11g specifications. Actual data throughput will vary. -
Page 3: Hardware Overview
Power is supplied to this port via an Ethernet cable LAN (PoE) Port that is connected to a PoE injector or a PoE switch. Connect a grounding wire to help prevent device Ground damage due to shorts and lightning strikes. DAP-3320 Install Guide... -
Page 4: Before You Begin
Failure to employ an experienced installer may render the D-Link product warranty void and may also expose the end user or the service provider to legal and financial liabilities. D-Link and its resellers or distributors expressly disclaim any and all liabilities for injury, damage, or violation of regulations due to the improper installation of outdoor units or antennas. -
Page 5: Installation
Installation 1. Lift the release tab in the middle of the cover, then pull the cover off. 2. Connect an Ethernet cable (not included) to the Ethernet port. DAP-3320 Install Guide... - Page 6 3. Use the grounding screw to attach the grounding wire. 4. Reattach the cover. You may need to break off one of the plastic port covers to allow your cables to exit the AP. DAP-3320 Install Guide...
-
Page 7: Pole Mount
It is highly recommended that you configure and test your access point before mounting it. Pole Mount Thread the plastic mounting ties through the back of the DAP-3320 and around the pole. DAP-3320 Install Guide... -
Page 8: Wall Mount
Screw the wall mounting bracket into the wall, then attach the Access Point to it. For extra security, you can thread the plastic mounting ties through the back of the Access Point and the wall mounting bracket as shown. DAP-3320 Install Guide... -
Page 9: Connect To Your Network
Connect to Your Network You can connect the DAP-3320 to a PoE switch, or you can use a PoE injector to power the AP. Connecting to a PoE Switch Connect the Ethernet cable that is connected to the DAP-3320 to your PoE switch. - Page 10 Connecting to the PoE Injector 1. Connect the Ethernet cable that is connected to the DAP-3320 to the P+DATA OUT port on the PoE injector. 2. Connect an Ethernet cable to the DATA IN port on the PoE Injector. Connect the other end of the Ethernet cable to your network switch or router.
- Page 11 Click Login to continue. Step 3: After the home page appears, go to Basic Settings > LAN to change the IP settings of the DAP-3320. Go to Basic Settings > Wireless to configure your wireless settings. Note: Make sure you click on Configuration > Save and Activate to save your settings.
-
Page 12: Technical Support
Copyright ©2016 D-Link Corporation/D-Link Systems, Inc. All rights reserved. D-Link and the D-Link logo are trademarks or registered trademarks of D-Link Corporation or its subsidiaries in the United States and other countries. Other trademarks are the property of their respective owners. All references to speed are for comparison purposes only. Product specifications, size, and shape are subject...