Configure Wep - D-Link DAP-3310 User Manual

Section 4 - Security
It is recommended to enable encryption on your wireless access point before your wireless network adapters. Please establish
wireless connectivity before enabling encryption. Your wireless signal may degrade when enabling encryption due to the
added overhead.
1. Log into the web-based configuration by opening a web browser and entering the IP address of the access point (dlinkap.
local). Click on Setup and then click Wireless.Setup on the left side.
2. Next to Security Mode, select WEP.
Note: Choosing WEP means the device will only operate in Legacy wireless mode (802.11B/G) and will not provide 802.11N
performance.
3. Next to WEP Encryption, select 64Bit(10.hex.digits),.64Bit(5.ASCII.characters), 128Bit(26.hex.digits).or 128Bit(13.ASCII.
characters).
4. Next to WEP Key 1, enter a set of digits or letters from A to F, or a string of text.
5. Next to Authentication, select Both or Shared.Key.
6. Click Save.Settings at the top of the window to save your settings. If you are configuring the access point with a wireless
adapter, you will lose connectivity until you enable WPA-PSK on your adapter and enter the same passphrase as you did on
the access point.
D-Link DAP-3310 User Manual

Configure WEP

65