Alarm Operation - Marmitek 14” COLOR OBSERVATION SYSTEM Owner's Manual

AUXILIARY OPERATION

ALARM OPERATION

A. Monitor Alarm Circuit
B. Alarm Connection There are two ways to connect with alarm. One is to connect with terminal
Block on the back panel of monitor and the other is with AUX port on rear panel of camera.
B-a. Terminal Block Connection
ALARM DEVICE INSTALLATION (In case of using TIME LAPSE VCR)
1. SW IN -GND
-VTI
2. ALARM OUT -HOT/COLD : This is the ALARM OUT for the Time Lapse VCR or ALARM system.
3. ALARM IN -CH1~CH4
19
MONITOR ALARM CIRCUIT
: This is the COMMON Ground for ALARM OUT & IN.
: This is the Trigger Input from the Time Lapse VCR for changing the channel
for multiplexing recording.
(This terminal is normally open)
If the alarm is occured, this terminal is switched to closed. ("ACTIVE MAKE")
: These terminals are assigned to each camera alarm sensor or the special
alarm system.
The alarm sensor must be normally open type.
or
ALARM SYSTEM
SENSOR 1
SENSOR 2
SENSOR 3
SENSOR 4