Observation Camera Operation; Camera Part - Marmitek 14” COLOR OBSERVATION SYSTEM Owner's Manual

OBSERVATION CAMERA OPERATION

CAMERA PART

1
1. CCD CAMERA LENS
Deliver sharp image to the CCD sensor.
2. MICROPHONE
Pick up sound around the camera.
3. SPEAKER
Delivers the sound from the monitor
4. ALARM TERMINAL
Connect an optional alarm device to this
terminal.
IN Alarm input (normally open)
IN
GND Ground
GND
B+
B+ Power output +12V DC 100mA
TERMINAL
Permanent installation using pedestal stand.
1. Attach the Pedestal using 4 screws.
CAUTION : Keep camera installed away from direct sunlight. Also avoid places where humidity is high or
where the camera is not protected from rain. The mounting bracketmust be attached to a
structural object such as a wall stud or ceiling rafter using suitable fastener. Do not touch the
glass of the lens. This could damage the delicate coating on its surface. If the lens has to be
cleaned, use a special lens cleaning tissue available at any good camera store.
9
DIN TYPE
4
TERMINAL
5
TO MONITOR
3
2
10
RJ TYPE
6
INTERPHONE
7
MONITOR
5. MONITOR INPUT JACK
Din connect the cable with the monitor.
6. INTERPHONE
7. MONITOR INPUT JACK
RJ-11 Connector cable to the monitor.
8. DC IRIS LENS CONNECTOR
When using on DC iris lens.
9. LEVEL
Auto DC iris type video level control.
10. BRACKET
2. Attach the Camera onto the Pedestal
and tighten the screw.
IRIS
8
9
LEVEL