Maintenance - Greenlee 43180 Instruction Manual

Maintenance

Wear eye protection when operating
or servicing this tool.
Failure to wear eye protection could
result in serious eye injury from flying
debris or hydraulic oil.
• Do not change accessories, inspect, adjust, or
clean tool when it is connected to a power source.
Accidental start-up can result in serious injury.
• Inspect blades before installing and before
operating. Do not use a damaged or worn blade.
A damaged blade can break and injure nearby
personnel. Destroy the blade if cracks, chips,
gouges, or loose or missing teeth are evident.
• Blade must be installed to rotate correctly. Refer
to the Illustrations and Parts Lists and blade
manufacturer's instructions. An improperly installed
blade can result in injury.
• Always wear protective gloves when handling or
adjusting the blade. The blade can cut even when
stationary.
Failure to observe these warnings could result in
severe injury or death.
Greenlee / A Textron Company
43180 Overhead Circular Saw
Use this maintenance schedule to maximize the tool's
service life.
Notes: Keep all decals clean and legible, and replace
when necessary.
When disposing of any components (hydraulic hoses,
hydraulic fluid, worn parts, etc.), do so in accordance
with federal, state, and local laws or ordinances.
Daily
1. Wipe all tool surfaces clean, especially fiberglass
extension.
2. Inspect blade mounted on saw. Remove and
destroy blade if cracks, chips, gouges, or loose
or missing tips are evident.
3. Inspect the hydraulic hoses and fittings for signs
of leaks, cracks, wear, or damage. Replace if
necessary.
4. Install dust caps over the hydraulic ports when the
tool is disconnected.
Monthly
Perform a thorough inspection of the hydraulic hoses
and fittings as described in publication 99930323,
SAE J1273 (Hose and Hose Assemblies).
Annually
Some organizations require an annual inspection.
Have the tool inspected by a Greenlee Utility Authorized
Service Center.
12
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070