Inspection - Greenlee 43180 Instruction Manual

Inspection

Refer to the Illustrations and Parts Lists.
Clean all parts with an appropriate cleaning solution
and dry them thoroughly. Inspect each component as
described in this section. Replace any component that
shows wear or damage.
1. Bearing (13): Hold center hub of bearing between
your thumb and index finger. Roll outer surface
against palm of your other hand. Motion should be
smooth with no rough spots. If not, replace bearing.
2. Needle Bearings (3): Hold motor cap or motor body
in one hand, or place on a flat surface. Insert drive
shaft or idler shaft in bearing. Spin shaft. Shaft and
bearing should turn smoothly. If not, Greenlee Utility
recommends replacing motor body or motor cap as
an assembly with bearing already pressed in.
3. Motor Body (1) and Motor Cap (11): Mating
surfaces, gear cavities, oil passageways, etc., in
components must be smooth and free of grooves
or nicks. If not, replace component as an assembly
with bearings already pressed in.
Greenlee / A Textron Company
43180 Overhead Circular Saw
4. Drive Shaft (6) and Idler Shaft (4): All surfaces must
be smooth and free of grooves or nicks. If not,
replace component.
5. Spool (9) and Sleeve (2): All surfaces must be
smooth and free of grooves or nicks. If not, replace
component.
6. O-rings: Always replace O-rings in components that
have been disassembled with new O-rings during
assembly. A packing kit is available that includes all
O-rings and gasket.
7. Gasket (9): Always replace gasket when motor cap
is removed from motor body.
17
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070