Operating Instructions; Maintenance Schedule - Greenlee Fairmont H4645 Operation, Service And Parts Manual

Operating Instructions

1. See "Setup Instructions" on page 10 to properly
attach Rail Cut-Off Saw to rail.
2. Remove enough ballast from beneath rail to provide
cutting wheel clearance.
3. Connect hoses to proper ports.
(See "Tool/Hose Connections".)
4. Start the power source.
5. Push spool down to its stop. This changes the
direction in which the cutting wheel rotates.
Note: The cutting wheel should rotate forward,
away from the operator, so that sparks are
sent downward into the ballast.
6. Squeeze the trigger to start tool.
Note: Do not rest the cutting wheel on the rail when
starting the tool.
7. Allow wheel to spin up to speed before cutting.
8. Cut using a rocking motion. This prevents localized
overheating of the rail and reduces wear on cutting
wheel.
Greenlee Textron Inc. / Subsidiary of Textron Inc.
H4645 Rail Cut-Off Saw
Pivot Function
Cutting from opposite side of rail:
1. Stop the tool.
2. Use handle to lift and pivot tool so that cutting wheel
edge faces desired direction.
3. Push spool down to its stop. This changes the
direction in which the cutting wheel rotates.
Note: The cutting wheel should rotate forward,
4. Squeeze the trigger to start tool.
Note: Do not rest the cutting wheel on the rail when
5. Allow wheel to spin up to speed before cutting.
6. Cut using a rocking motion. This prevents localized
overheating of the rail and reduces wear on cutting
wheel.
PUSH SPOOL
DOWN
12
away from the operator, so that sparks are
sent downward into the ballast.
starting the tool.
4455 Boeing Dr., Rockford, IL 61109-2988 815/397-7070
FORWARD
ROTATION