Important Safety Information - Greenlee 43180 Instruction Manual

IMPORTANT SAFETY INFORMATION

This symbol is used to call your attention to hazards
or unsafe practices which could result in an injury or
property damage. The signal word, defined below,
indicates the severity of the hazard. The message
after the signal word provides information for
preventing or avoiding the hazard.
Immediate hazards which, if not avoided, WILL result
in severe injury or death.
Hazards which, if not avoided, COULD result in
severe injury or death.
Hazards or unsafe practices which, if not avoided,
MAY result in injury or property damage.
Read and understand all of the
instructions and safety information
in this manual before operating or
servicing this tool.
Failure to observe this warning could
result in severe injury or death.
Greenlee / A Textron Company
SAFETY
ALERT
SYMBOL
43180 Overhead Circular Saw
Electric shock hazard:
• This tool was tested to meet
OSHA 1910.269 (dry test) when
manufactured. It must be properly
cleaned and maintained to ensure
continued non-conductive prop-
erties. When using this unit near
energized electrical lines, use only
certified non-conductive hoses
and proper personal protective
equipment.
• Keep fiberglass extension clean
and dry when working around
energized electrical lines.
Accumulated oil, dirt, and moisture
increase the conductive properties
of the tool.
Failure to observe these warnings
could result in severe injury or death.
Skin injection hazard:
• Do not use hands to check for
leaks.
• Do not hold hose or couplers while
the hydraulic system is pressurized.
• Depressurize the hydraulic system
before servicing.
Oil under pressure easily punc-
tures skin, causing serious injury,
gangrene, or death. If you are injured
by escaping oil, seek medical atten-
tion immediately.
Burn hazard:
Tool motor and blade may be hot
during and after operation. Hot
surfaces could cause serious burns.
3
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070