Important Safety Information - Greenlee 43180 Instruction Manual

IMPORTANT SAFETY INFORMATION

• Always use blades that meet applicable industrial
safety code specifications.
• Always use blades rated for 5400 rpm or higher.
• Blade must be installed to rotate correctly.
Refer to the Illustrations and Parts Lists and blade
manufacturer's instructions. An improperly installed
blade could result in injury.
• Inspect blades before installing and before oper-
ating. Do not use a damaged or worn blade.
A damaged blade can break and injure nearby
personnel. Destroy the blade if cracks, chips,
gouges, or loose or missing teeth are evident.
Failure to observe these warnings could result in
severe injury or death.
Hydraulic oil can cause skin irritation.
• Handle the tool and hoses with care to prevent
skin contact with hydraulic oil.
• In case of accidental skin contact with hydraulic
oil, wash the affected area immediately to remove
the oil.
Failure to observe these precautions may result in
injury.
• Inspect tool before use. Replace any worn,
damaged, or missing parts. A damaged or
improperly assembled tool can malfunction, injur-
ing nearby personnel.
• Inspect the hydraulic hoses and couplers every
operating day. Repair or replace if leakage, crack-
ing, wear, or damage is evident. Damaged hoses
or couplers can fail, resulting in injury or property
damage.
• Use this tool for manufacturer's intended purpose
only. Use other than that which is described in this
manual can result in injury or property damage.
• Make sure that all bystanders are clear of the work
area when operating the tool. Nearby personnel
can be injured by flying debris.
Failure to observe these precautions may result in
injury.
Greenlee / A Textron Company
43180 Overhead Circular Saw
Procedure for connecting or disconnecting hydraulic
hoses, fittings, or components:
1. Move the flow lever on the hydraulic power
source to the OFF position.
2. Stop the hydraulic power source.
3. Follow the sequence under "Hose Connections"
to prevent pressure buildup. In case some
pressure has built up, loosen hoses, fittings, or
components slowly.
Emergency stop procedure:
1. Release the trigger.
2. Shut off the hydraulic power source.
Note: Keep all decals clean and legible, and replace
when necessary.
5
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070