One-Time Valet Feature; Blackjax Feature; Blackjax Activation Sequence - Clifford AvantGuard 5 Installation Manual

one-time valet feature

This feature allows the system to be put in valet mode only until the next time the
ignition is turned off.
ON: Valet mode will be exited every time the ignition is turned on.
OFF: Valet mode will only be exited by using the valet switch or the remote control.

blackjax feature

blackjax activation sequence

When BlackJax is programmed ON, BlackJax sequence will begin every time the igni-
tion is turned on and must be turned off by entering your PIN code. It will then acti-
vate again while driving when triggered as described below.
N N O O T T E E : : BlackJax can be turned off by entering PIN code at any time.
1. Ignition on (engine does not have to be running)
System sees input on Zone 7 ignition input.
2. Door Open & Close.
System sees input on H1/8 or H1/9 Door trigger input.
3. Press and release brake pedal.
a. System sees (+) input on H2/11 BROWN/WHITE brake input/output wire.
b. System then begins monitoring input on H1/4 VIOLET/BLACK wire or
Intellistart 4.
5. If PIN code is NOT entered within 20 seconds:
System sounds siren and begins flashing parking lights.
Brake lights continue to flash.
The system will now immobilize as described in steps 6-7.
6. If system sees the RPM rate return to 1 ½ times programmed RPM rate or lower,
the system will immobilize the vehicle as described in step 7.
7. Vehicle Immobilization:
immobilizer will engage the starter and ignition circuits.
The siren will continue to sound and the parking and brake lights will flash
for a maximum of 5 minutes.
Immobilization circuits will remain active until correct PIN code is entered.
© 2004 directed electronics, inc.
55