Primary Harness Wiring Guide - Clifford AvantGuard 5 Installation Manual

primary harness wiring guide

This guide describes in detail the connection of each wire. Also included are possible appli-
cations of each wire. This system was designed with the ultimate in flexibility and security
in mind. Many of the wires have more than one possible function. Please read the instruc-
tions carefully to ensure a thorough understanding of this unit and how it operates.
h1/1 black ground
Connect the BLACK wire to a clean, paint-free sheet metal location (driver's kick panel)
using a factory bolt that does NOT have any vehicle component grounds attached to
it. A screw should only be used in conjunction with a two-sided lock washer. Under
dash brackets and door sheet metal are not acceptable ground points. It is recom-
mended that all security components be grounded at the same location.
h1/2 and h1/11 brown speaker outputs
Connect the BROWN output wires to the BROWN wires of an optional 518C Neo Siren.
h1/3 gray (-) hood input zone 6
Connect this wire to the hood pin. If the hood is open when the alarm is armed, this
wire will trigger the siren. Use either this wire (preferred) or the wire from the
Intellistart module, but not both.
10
www.directed.com