Jackson AJ-44 Installation/Operation & Technical Manual page 44

SECTION 2: INSTALLATION/OPERATION INSTRUCTIONS
CHANGING THE AJ-44CE/CS DIRECTION OF TRAVEL (CONTINUED)
Removing the locknuts for the lower wash arm
support bracket.
9. Remove the lower rinse arm support bracket, which is
mounted directly opposite of the lower wash arm support
bracket.
Removing the lower rinse arm support bracket
10. Remove the lower and upper rinse arms by unscrewing
them and then gently pulling them out.
Unscrewing and removing the lower rinse arm
11. Behind the rinse manifold, remove the nut on the bracket.
12. Remove the nuts from the rinse manifold mounting brack-
et located on the underside of the hood. These nuts are
mounted directly to the rinse injector weldment on the hood
top.
13. The rinse manifold must be removed. This may prove dif-
ficult while the rinse injector is still mounted. With great care,
it is possible to gently lift the rinse injector off of the hood to
allow the rinse manifold to be removed from the unit. Ensure
that the gasket in the underside of the hood stays with the
rinse manifold as it must be replaced when re-installing the
manifold. If the gasket becomes lost or torn, order a new one
immediately.
14. Remove the entire rinse tray assembly, including the pan
AJ-44C Series Technical Manual 7610-001-76-22
Issued: 03-21-2006 Revised: N/A
36
Removing the bracket nut
Removing the locknuts from the rinse mani-
fold mounting bracket
Lifting the rinse injector to make room