Card Installation; Figure 7: Removing The Top Cover Of The D6600 - Bosch D6600 Operation And Installation Manual

Receiver/gateway
Hide thumbs Also See for D6600:
Table of Contents

Advertisement

D6600 | Operation and Installation Guide | 4.0 D6600 Specific Cards
4.1.2

Card Installation

Power down the receiver when removing,
replacing, or installing telephone line
cards or telephone line terminator cards
(refer to Section 7.7 Powering Down the
Receiver on page 13).
Discharge static electricity from your body
by touching the receiver's internal frame
(unpainted section) before handling any
circuit card.
Installing Telephone Line Terminator Cards
1. Remove the rear slot cover (Item 3, Figure 2 on
page 8).
One telephone line terminator card is installed in
the receiver when shipped from the factory.
2. Insert a terminator card in the slot next to the
installed telephone line terminator cards.
Figure 7:
Removing the top cover of the D6600
2
1
3. To replace a failed terminator card, remove the six
screws (Item 1, Figure 7). Hold the top metal cover
of the D6600 and lift it off (Item 2, Figure 7).
4. Remove the defective card.
5. Insert the new card in the same slot by aligning the
top and bottom of the terminator card with the
card guides in the enclosure.
10
Figure 8:
Inserting the D6645 Line Terminator
Card
4
1
1 - Alignment slot
2 - Alignment guide tab
6. Slide the card into the enclosure so the alignment
guide (Item 2, Figure 8) tab on the back of the
terminator card (Item 3) inserts into the alignment
slot (Item 1) in the back of the D6600's back plate
(Item 4) circuit board.
Figure 9:
Securing the D6645 Line Terminator
Card
2
3
2
1 - D6645 Line Terminator Card
2 - Bracket screws (top and bottom)
3 - Empty slot
4 - D6600
Bosch Security Systems | 2/05 | 4998122704E
3
2
3-
D6645 Line
Terminator card
4 - D6600 Back plate
4
1

Advertisement

Table of Contents
loading

Table of Contents