Printing Limitations - Konica Minolta bizhub 751 User Manual

Receiving data (G3/IP/I-FAX)

Printing limitations

If the paper actually used for printing is smaller than the paper size determined in Step 1, the document is
reduced in size when printed.
When [Print Separate Fax Pages] is set to [OFF], the printing orientation is automatically rotated by 90
degrees if the orientation of the paper actually used for printing does not match that of the paper determined
in Step 1.
Note
For details on [Print Separate Fax Pages], refer to "Print Separate Fax Pages" on page 10-30.
When a document using paper of different sizes is printed out, these operations are performed page by page.
When paper of the sizes determined in Steps 1 and 2 are prepared in two or more paper trays, a paper tray
is selected according to the settings specified for [Auto Tray Selection Setting].
If paper of an applicable size is only set in the bypass tray, printing is performed using paper in the bypass
tray. However, if the bypass tray is not specified for "Auto Tray Select" when setting [Auto Tray Selection
Setting], paper is not fed from the bypass tray.
Note
For information on [Auto Tray Selection Setting], refer to the User manual – Copy Operations.
When [Print Separate Fax Pages] is set to [ON], printing is not output on separate pages if [TX/RX Settings]
in the Utility mode screen is set as follows:
- A fixed tray is specified using [Tray Selection for RX Print].
- [Min. Reduction for RX Print] is set to "
- [Print Paper Selection] is set to [Fixed Size] or [Priority Size].
- [Duplex Print (RX)] is set to [ON].
Note
For details on [Tray Selection for RX Print], [Min. Reduction for RX Print], [Print Paper Selection], and
[Duplex Print (RX)], refer to "Fax Settings - TX/RX Settings" on page 10-26.
If no paper applicable for printing is prepared, a message appears, prompting to set paper.
- When [Print Paper Selection] is set to [Priority Size], either 8-1/2
A3) is selected as the optimal paper size. If paper of that size is not in the tray, the standard paper
selection is performed for printing.
- When [Print Paper Selection] is set to [Fixed Size], either 8-1/2
A3) is selected as the optimal paper size. If paper of that size is not in the tray, a message is displayed
until paper of the relevant size is supplied.
- When [Tray Selection for RX Print] is set to an option other than [Auto Paper Select], paper in the paper
tray specified for [Tray Selection for RX Print] (except for the bypass tray) is used for printing. If the width
of the paper is smaller than that of the received document, printing is performed in a reduced mode. If
the specified paper tray is empty, a message is displayed until paper of the relevant size is supplied.
- When [Print Paper Selection] is set to an option other than [Auto Select], and [Tray Selection for RX
Print] to an option other than [Auto Paper Select], the setting for [Tray Selection for RX Print] is given
priority.
bizhub 751/601 (Version 2)
1.0".
e
e
e
11, 8-1/2 14, or 11 17 (A4, B4, or
e e
11, 8-1/2 14, or 11 17 (A4, B4, or
e e
6
6-11