Page 1
P R E 3 5 P R E a m P l i f i E R User Guide...
Page 2
E. the appliance has been dropped or the enclosure accessible. 2. Water and moisture damaged. Only connect the appliance to a power supply of the type The presence of electricity near water can be dangerous. PRE35 Preamplifier User Guide...
Page 3
1. This device may not cause harmful interference, and minimale de 0 cm entre le radiateur et votre corps. . This device must accept any interference received, The CE symbol indicates that this Primare product including interference that may cause undesired This device complies with Industry Canada licence-exempt complies with the EMC (Electromagnetic Compatibility) operation.
Back-panel connections Phase Using the remote control Burn-in Selecting PRE35 mode RS232 and trigger Fitting the batteries Using the PRE35 with a CD35 Error messages Using the PRE35 Factory reset Front panel controls index Changing the volume Selecting a source...
For additional support and assistance please contact your local authorized Primare dealer, or visit our website at www.primare.net. PRE35 Preamplifier User Guide...
Connect the PRE or PRE3 L and R outputs from the C5 remote control with batteries PRE35 to the L and R balanced inputs in the power Note: See Phase , page 1, for information about getting AC Polarity Pen amplifier, using high quality XLR cables.
Slot for Slot for network module DAC module On/off ANALOG OUT PRE1 PRE2 PRE3 WiSA RS232 Trigger Balanced Unbalanced Analogue Balanced Power and transmitter button analogue inputs analogue inputs outputs analogue outputs fuse in/out and status PRE35 Preamplifier User Guide...
Press and hold to switch all Primare products to standby Indicators light when To make the remote control operate the PRE35 pressing a button Press the PRE aUX button once. Top: AMP, PRE, or CD mode Bottom: AV, SC, or AUX mode...
1 to 5 on the remote control to select the Changes the volume. corresponding source directly. Changing the volume The PRE35 allows you to vary the volume from 0 (silence) to 99 (maximum). To change the volume Rotate the VOlUmE control on the front panel, or press the + or –...
Press the R button on the front panel, or the SElECT Fixed gain functions as an SSP (Surround Sound Pass- button on the remote control. RENAME INPUT through) allowing the PRE35 to be used as an amplifier in a multi-channel system setup The current value is shown highlighted. iNPUT GaiN...
0. To unlock the front panel buttons use the remote control to maXimUm VOlUmE select this menu, or remove power from the PRE35 for a Sets the maximum volume limit between 0 and 99. The few seconds. default is 99.
1 x RCA, 100Ω impedance 30 x 38 x 106 mm (w x d x h) without knobs and connectors Wireless output Weight 1x Wireless stereo output using WiSA® technology (future 11 kg software upgrade) Colour Black or titanium PRE35 Preamplifier User Guide...
If this solves the problem, check the speaker wiring. RS232 and trigger If the problem persists The RS3 input allows you to connect the PRE35 to a Power off PRE35 and disconnect all input connections. controller system. Use a twisted (null modem) cable. For If this solves the problem, there is a DC offset on one of more information contact Primare at info@primare.net or...
Page 16
T H E S O U N D A N D V I S I O N O F S C A N D I N A V I A S I N C E 1 9 8 6 L I M S T E N S G A T A N 7 , 1 6 1 6 L I M H A M N , S W E D E N More information at primare.net...