Additional Information; Best Sound; Burn-In; Rs232 - Primare PRE60 User Manual

AdditionAl infoRmAtion

These instructions help you get the best possible sound
from your PRE60, and give information about using it with
the A60 and your Primare sources.

BESt Sound

The phase of the AC supply can make a significant
difference to the sound.
Ensure that the live pin of the AC power cable is
connected to the left-hand pin of the power connector,
viewed from the back panel:
Live

BuRn-in

Your Primare will sound best after an initial burn-in of
approximately 48 hours.
You will notice a further smaller improvement in sound
quality for at least another 3 days' playing.
RS
The RS232 input allows you to connect the PRE60 to a
controller system. For more information please contact
Primare or visit www.primare.net.
The Trigger output allows the PRE60 to switch on other
devices, such as a Primare source.
16

tRiGGER inPut/outPut

The trigger input and output allow you to link your
Primare products together, using the trigger cable
supplied with each product, so they switch on or to
standby in sync with the PRE60.
To link the PRE60 to a Primare source
•
Connect the trigger cable from the PRE60 TRIG OUT to
the source TRIG IN.
•
If necessary, configure the source to TRIG ON.
To link the Primare source to the A60
•
Connect the trigger cable from the source TRIG OUT to
the A60 TRIG IN.
To link two A60 amplifiers for bi-amping
•
Connect the trigger cable from the first A60 TRIG OUT
to the second A60 TRIG IN.
PRE60 Audiophile Preamplifier, dAC, Streamer user Guide