Table of Contents
Advertisement
6. Using the UPS monitoring software and contact signal
6-4 When performing auto-save functions using the
standard UPS service in Windows Server 2003/
XP/2000/NT
When using in combination with the optional BUC26 cable, the OS standard UPS service in Windows Server
2003/XP/2000/NT can be used. When there is a power failure, the computer can be shut down.
1. Connect the UPS to a computer.
Cable: Connection cable (BUC26), sold separately
* Set the switching switch on the back of the unit to "contact".
Connect to
RS-232C
terminal
Connector
Connect to
RS-232C port on PC
2. Perform UPS service setup.
You need to make Windows settings in order to perform auto shutdown. There is no need to install software.
<When using the Windows Server 2003/XP/2000 standard UPS service>
Start up the computer after connecting it with the UPS.
Perform "Log on to Windows" as the Administrator.
After logging on, follow the instructions below to set up the UPS service.
How to set up UPS service (shut down Windows when low battery level is detected)
1) Double-click the "Power supply options" icon in "Control Panels".
2) Click the "UPS" tab in the "Power supply options" window.
Click the "Select (S)" button.
Connector
Connect to the
UPS serial communication
interface (RS232C) port
BY50FW
BUC26 cable
Connect to
RS-232C
terminal
Connector
Connect to
RS-232C port on PC
BY75SW
BUC26 cable
Click
Click
52
Connector
Connect to the UPS
serial communication
interface (RS232C) port
Hide quick links:
Advertisement
Table of Contents
