Omron POWLI BY50FW Instruction Manual page 51

Operation start using the UPS monitoring software during scheduled stop
If the unit starts operation during a scheduled stop period, the next set scheduled ON operation is
cancelled after the power switch is turned OFF.
Auto restart after OS shutdown by UPS monitoring software
In the event of a power failure, some PC models (see Note 1 below) automatically restart immediately
after the completion of the OS shutdown processing by the UPS monitoring software.
In this case, the unit stops during restart or after startup, possibly damaging files and/or the hard disk.
This problem can be avoided by disabling POWER MANAGEMENT in the BIOS settings.
*1) PC models: This problem has been reported with MICRON Millennia Mme.
When the PC does not start up automatically, select the "System startup at power restoration" setting
(example: "Restore On AC/Power Loss) in the BIOS settings of your PC, and change to a "System
startup after power restoration" setting (example: Power On). Individual BIOS setting methods and/or
displays may differ depending on the PC. For more information, refer to your PC instruction manual or
the technical support center for your PC.
When considering a system with automatic startup at power restoration, choose a PC that satisfies the
condition shown below. For more information on PC operation when input power is supplied, consult
your PC instruction manual or contact the PC technical support center.
<Condition>
Without pressing the power switch, the PC starts up when input power is supplied.
After shutdown processing in the event of a power failure, the unit restarts automatically and supplies
power once power is restored. If you do not want the devices connected to start up, turn OFF their
switches while the power is out.
The automatic restart setting can also be disabled in the included UPS monitoring software.
6. Using the UPS monitoring software and contact signal
Explanation
49