Error Messages - Sony UP-980 User Manual

Error Messages

100
Others
If a problem occurs, an error message stating the problem appears in the printer
window display. This section lists error messages together with their possible
causes and remedies. Note the messages and act accordingly.
Error message Possible cause and remedies
MOTOR TROUBLE Motor trouble has occurred.
n Contact your Sony service facility or Sony dealer.
SENSOR TROUBLE Sensor trouble has occurred.
n Contact your Sony service facility or Sony dealer.
CHECK PAPER The paper roll has been exhausted. Or the paper is not loaded
correctly.
n Load the paper correctly. (page 58)
NO INPUT The printer is not receiving an input signal.
n Check that the connections between signal source equipment
n Check whether the video equipment is outputting a video
PLEASE WAIT Please wait a little while.
PLEASE WAIT HEAD The thermal head has overheated.
IN COOLING
n Leave the printer until the head cools down and this message
DOOR OPEN The door panel is open.
n Close the door panel.
INPUT MISMATCH A different signal
n Check the input signal.
OVER SPEC The signal of the horizontal scanning frequency and the number of
lines over the specified values is input.
n Check the input signal.
NO IMAGE The COPY button is pressed when no image is captured.
Press the PRINT button to capture the image in the single picture
mode. (page 61)
Press the CAPTURE button to capture the image in the multi
picture mode. (page 64)
1) The different signal has two kinds of meanings.
One — the signal is different from the currently selected signal. For example, when the settings of
LOAD 1 are loaded, the signal specification saved in LOAD 1 is different from the previous signal.
The other meaning is when the signal whose horizontal scanning frequency and the number of lines
are different from those of the current signal is input, with AUTO SCAN set to OFF.
and the printer are secure. (page 73)
signal in playback mode.
disappears.
1) is input.