Wiring Connection - JVC KD-X250BT Instruction Manual

Wiring connection

MIC (Microphone input terminal) (A page 11)
Rear ground terminal
Factory wiring
harness (vehicle)
Recommended
connection
Blue: To power antenna
Blue/white: To amplifier
Telephone muting
Vehicle-specific Wiring Harness
(separately purchased)
*1 Not supplied for this unit.
*2 Insulate to prevent short circuit.
If you have any troubles, try the following:
1
Check "Troubleshooting" (
2
Reset the unit. (
3
Contact (USA only)
Call: 1-800-252-5722 ( or ) visit: http://www.jvc.com
Antenna terminal
To the steering wheel
remote control adapter
Join the same color wires
together.
Blue/white:
Remote (200 mA max.)
Orange/white: Illumination
(not used) *
Yellow: 12 V Battery
Red: 12 V Ignition switch
Black: Ground
White: Front speaker (left)
White/black
Gray: Front speaker (right)
Gray/black
Green: Rear speaker (left)
Green/black
Purple: Rear speaker (right)
Purple/black
page 26).
page 3)
Installation/Connection
1
Signal cord*
Rear/subwoofer
10 A fuse
output
Light blue/yellow
2
For more information:
Metra Electronics:
Scosche Industries:
JVC Amplifier
Remote
1
wire*
Ignition switch
Fuse block
Separate
red wire
Make this connection
if your vehicle factory
wiring harness does
not have "12 V
ignition switch" wire.
www.metraonline.com
www.scosche.com
ENGLISH | 31