Club Car 2009 Precedent Owner's Manual page 56

Engine Oil – Gasoline Vehicles
5. Use a 14 mm socket or wrench to remove the drain plug, turning it counterclockwise, and allow the engine
oil to drain into the pan. See following WARNING.
WARNING
• Do not attempt to change engine oil when the engine is hot or even warm. Engine oil can cause
skin burns.
• Wear safety glasses or approved eye protection when servicing the vehicle. Wear rubber gloves when
handling oil drain plug, oil filter, and oil drain pan.
6. Clean the oil drain plug threads with solvent to remove oil and oil residue. Make sure that the compression
washer remains on the drain plug.
7. Use a 14 mm socket or wrench and replace the front oil drain plug, turning it clockwise, and tighten to 18 ft-lb
(24.4 N·m).
8. Relocate the oil drain pan to a position under the engine oil filter (Figure 38).
9. Remove the engine oil filter, turning it counterclockwise, allowing the residual oil in the filter port and filter to drain
into the oil drain pan (Figure 39). See following NOTE.
NOTE: An oil drip guard can be used to prevent excess oil from dripping into the engine base plate. Use an empty
quart (one liter) container and cut the bottom off at an angle, then slide the open area of the container up and
under the oil filter prior to removing. Position the port of the plastic container so oil will be directed into the oil
pan. Or, make a drip guard by folding a piece of cardboard, thin metal, or plastic under the oil filter forming a
channel to direct the filter port oil into the drain pan.
Dispose of used oil according to the environmental laws and regulations for your area.
26
Figure 39 Remove Engine Oil Filter
10. Use a clean rag and wipe the oil filter mounting bracket surface clean where the oil filter gasket seats.
11. Coat new oil filter gasket with clean engine oil, Install the oil filter onto the engine oil filter port (Figure 40).
NOTE: Use only Club Car oil filters (CC P/N 1016467) designed for this engine.
12. Hand tighten 2/3 to 3/4 turn after filter gasket contacts mounting surface.
13. Remove the dipstick and add engine oil into the dipstick port. With filter change, the engine requires 38 ounces
(1.12 liters) of oil per change. Refer to oil viscosity guidelines for selection of oil grade (Figure 41). See
following Caution.
Page 54 2009-2011 Precedent Golf Car Owner's Manual