Advertisement
2. Printer Settings (20 ppm copier)
Item No.
Page Protect
23
If "AUTO" is selected here, the machine will
monitor the data and, if necessary, will
automatically turn Page Protect ON. If a
"Print overrun" error does happen to occur
even then, the machine will automatically
change the Page Protect setting to "ON".
Line Feed (LF) handling
24
Carriage Return (CR) handling
25
Wide A4 ON/OFF
26
Increases the printing area on A4 size paper.
Smoothing ON/OFF
27
Allows a printing resolution of an interpo-
lated 2400 dpi x 600 dpi through the
smoothing process.
Draft Mode ON/OFF
28
Allows printing in a toner-saving mode. This
mode is especially suited for test pages, etc.,
where high printing quality is not required.
Printing resolution
29
RAM disk ON/OFF
30
RAM disk size
31
Sets the amount of memory that will be used
as a RAM disk. The maximum size that can
be selected is the total amount of memory
installed minus the amount used by the
system (9 MB).
Reading data
32
Reads the selected data on the RAM disk.
Reading program data
33
Reads the selected program data on the
RAM disk.
Writing data
34
If "OK" is selected here, the machine will
enter a "waiting for data" state until data is
sent from the host computer. To exit this
state, select the "GO" command in the
printer mode and then press the Enter key.
Item
Display message
Available settings
Page Protect
Auto, On
LF Action
LF only,
CR and LF,
Ignore LF
CR Action
CR only,
CR and LF,
Ignore CR
Wide A4
On, Off
KIR Mode
On, Off
Draft
On, Off
Resolution
300 dpi, 600 dpi
RAM DISK Mode
On, Off
RAM DISK Size
01 - 99 (MBytes)
Read Data
Select the name of
the partition which
holds the data from
among those
displayed.
Read Program
Select the name of
the partition which
holds the program
from among those
displayed.
Write Data
OK
2-9
Remarks
Allows you to set different line
feed handling for the parallel
interface and the Network Card
(option). Select the desired
interface under the "Interface
selection" setting (item No.: 2).
Allows you to set different carriage
return handling for the parallel
interface and the Network Card
(option). Select the desired
interface under the "Interface
selection" setting (item No.: 2).
At least 16 MB of additional
memory (option) must be installed.
Displayed only when "On" is
selected under the "RAM disk ON/
OFF" setting (item No.: 30).
Displayed only when there is
appropriate data in the RAM disk.
Displayed only when there is
appropriate program data in the
RAM disk.
Displayed only when "On" is
selected under the "RAM disk ON/
OFF" setting (item No.: 30).
Advertisement
