Battery Precautions; Maintenance Instructions - Sealey VS8196 Instructions Manual

NOTE: Please check following methods to avoid injury.
 FOR WALLS
circuit breaker to the whole premises before using the tool.
 FOR PIPES: If you suspect a metal pipe could contain a live electrical
voltage, have a qualified electrician check the pipe before using.
 FOR AUTOMOBILES
inspection. Metal and liquid under the bonnet may be hot. Don't get oil or
fuel on the imager head.

4.3 Battery Precautions

Remove the batteries while cleaning the tool.
y
Remove the batteries before storing the tool for a long period of time to
y
prevent battery leakage from damaging battery compartment.
When necessary, replace all four (4) batteries with new ones.
y
Use only the size and type of batteries specified.
y
Be sure to install batteries with the correct polarity as indicated in the battery
y
compartment.
Properly dispose of batteries. Exposure to high temperatures can cause
y
batteries to explode. Do not dispose in fire.

4.4 Maintenance Instructions

NOTE: Make sure the batteries have been removed from the tool before
performing maintenance.
Tool maintenance must be performed by qualified repair personnel.
y
When maintaining, use only identical replacement components.
y
Do not attempt to take apart unless directed by the manual.
y
Follow instructions to replace accessories.
y
Do not use acetone to clean the tool. Instead, use alcohol. Avoid rubbing too
y
hard on the LCD screen. After using, wipe the display unit clean with
a dry cloth.
Stop using the tool if it starts smoking or emitting noxious fumes.
y
Always handle the tool with care. It is not shock-resistant and should not be
y
banged or dropped.
Do not disassemble the tool beyond
y
will void your warranty.
Page 11
:
For inspecting the wall cavities, ensure you turn off the
:
Ensure the automobile is not running during
Original Language Version
what is shown in the manual. Doing so
VS8196 Issue: 1 - 01/07/10