Table of Contents
Advertisement
3.2 The Imager Head and Cable Installation
To use the tool, the imager head and cable must be connected to the
handheld display unit. To connect the cable to the handheld display unit,
make sure the key and slot (Fig.6) are properly aligned. Once they are
aligned, finger-tighten the knurled knob to hold the connection firmly in
place.
3.3 Accessories Installation
The three accessories include magnet, hook and mirror (Fig.2). All are
attached to the imager head in the same manner. Hold the imager head as
shown in Fig.7, slip the end of the accessory over the flats of the imager
head and then rotate the accessory 90° to fix as shown in Fig.8.
Page 8
Fig. 6
Fig. 7 / 8
Original Language Version
VS8196
Issue: 1 - 01/07/10
Advertisement
Table of Contents
