Safety Precautions - Sealey TA500 Manual

IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREfULLy. NOTE THE SAfE OPERATIONAL REQUIREmENTS,
WARNINGS AND CAUTIONS. USE THIS PRODUCT CORRECTLy AND WITH CARE fOR THE PURPOSE fOR WHICH IT
IS INTENDED. fAILURE TO DO SO mAy CAUSE DAmAGE AND/OR PERSONAL INJURy AND WILL INVALIDATE THE
WARRANTy. PLEASE KEEP INSTRUCTIONS SAfE fOR fUTURE USE.
1

. SAfETy PRECAUTIONS.

 Wear safety eye protection that meets ANSI standards.
 Operate the vehicle to be tested in a well ventilated area. Exhaust gases are
poisonous. If necessary connect the vehicle exhaust to a fume extraction system.
 Place chocks in front of the drive wheels and never leave the vehicle unattended
whilst testing is in progress.
 Be extra cautious when working in close proximity to the ignition coil, distributor
cap, ignition wires and spark plugs. These components create hazardous voltages
when the engine is running.
 Ensure that the handbrake is on and the gearbox is in neutral or 'Park' for
automatic transmissions.
 Keep fire extinguishers nearby suitable for gasoline/ chemical/ electrical fires.
 Keep the code reader clean and in good condition.
 Remain vigilant when using the code reader on, or near, machinery where there are
rotational parts such as belts, pulleys and fans.
 Remove ill fitting clothing. Remove ties, watches, rings, and other loose jewellery,
and contain and/or tie back long hair.
 Maintain correct balance and footing. Ensure the floor is not slippery and wear
non-slip shoes.
 Keep Product Surfaces Clean and Dry.
DO NOT attempt to connect or disconnect any test equipment whilst the ignition

is on or the engine is running.
DO NOT use the code reader if damage is suspected. If suspected damage occurs

with the device, have it inspected by qualified service personnel before using it
again.
DO NOT get the code reader wet or use in damp or wet locations or areas where

there is condensation.
DO NOT use the code reader for any purpose other than for which it is designed.

DO NOT allow untrained persons to use code reader.

DO NOT use the code reader when you are tired or under the influence of

alcohol, drugs or intoxicating medication.
DO NOT operate in a potentially explosive environment/atmosphere.

WARNING: The warnings, cautions and instructions discussed in this instruction

manual cannot cover all possible conditions and situations that may occur. It must
be understood that common sense and caution are factors which cannot be built
into this product, but must be applied by the operator.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
ImPORTANT: No liability is accepted for incorrect use of this product.
WARRANTy: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INfORmATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
© Jack Sealey Limited
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park,
Bury St. Edmunds, Suffolk,
IP32 7AR
Original Language Version
01284 757500
01284 703534
1
www.sealey.co.uk
Web
sales@sealey.co.uk
email
TA500 Issue No.1 18/02/13