Christie L2K1500 User Manual page 70

Settings
Filter counter
This function is used to set a frequency for the filter
replacement.
Use the Point ed buttons to select Filter counter and
then press the Point 8 or the SELECT button to access the
submenu items.
Filter counter . . . . . . . . . Shows the total used filter time.
Filter counter remaining ... Shows the remaining time every
Filter counter timer . . . . . To set the timing of replacing with
Filter counter reset . . . . . To reset the filter counter. Select
Auto cleaning timer . . . . To schedule a filter cleaning task
✔Note:
• Normally, the filter cleaning unit automatically starts cleaning
the mesh filter either while cooling down the projector after
the power was turned off or after restarting the projector.
• When the icon as shown in Fig.3 appeared for the first time,
replace the filters as soon as possible. If you turn off the
projector before you replace the filters, the projector will turn
off 3 minutes after the power is turned on next time.
68
The filter counter is displayed in
red when filter counter exceeded
the time specified for Filter counter
timer, or filter clogging was
detected.
10% until the specified time
comes. (p.74). When the remaining
time reached 10%, it is displayed in
red.
a new filter. The filter replacement
icon appears when filter counter
exceeded the specified time or
filter clogging was detected.
(Options available for the mesh
filter:
Off/4000H/8000H/12000H/16000H,
Options available for an optional
smoke resistant filter:
Off/10H/15H/
20H)
Reset, press the SELECT button,
and select Yes in the confirmation
box (p.74).
when the length of time you used
the filter reached the specified
time. (Options: 50H, 100H(default),
150H).
Press the SELECT button to select Filter counter
timer and use the Point ed buttons to set
the timer. Select from (Off/ 4000H/ 8000H/
12000H/16000H) depending on the use
environment.
Fig.1
This icon is warning you that the
remaining time has exceeded the
specified time.
Fig.2
This icon is warning you that the
remaining time has reached 10%.
Fig.3
This icon is warning you that the
remaining time has reached 0% and
the filters need to be replaced as soon
as possible.
✔Note:
•
Fig.1, Fig. 2, and Fig. 3 appear at turning on and selecting input
source.
• Fig.1, Fig. 2, and Fig. 3 will not appear when the Display
function is set to Off (p.54) or during "Freeze" (p.31).
L2K1500 User Manual
020-000387-01 Rev.1 (05-2011)