Connecting Holder Chassis And Ca1 Board; Connecting Lcd Monitor And Lcd Holder - Epson PhotoPC600 Service Manual

4.1.5.6 Connecting Holder Chassis and CA1 Board

Here explains procedures of connecting holder chassis mounted with lens viewfinder and CA1
board. (Refer to figure4-26)
Step1. Push the holder chassis until it touches with CA2 board, putting the holder chassis
over the lens unit.
CAUTION
Be careful not to interfere with FPC, which is taped around the lens
unit, when you put the lens unit through the notch parts of holder
chassis. Two solenoid copper wires for driving aperture are coming out
of this FPC.
Step2. Fix the holder chassis with 3 screws 2x5(#100) from the back of CA1 board.

4.1.5.7 Connecting LCD Monitor and LCD Holder

Here explains procedure of connecting LCD monitor on the back of camera and LCD holder, which
supports LCD monitor. (Refer to figure4-27)
Step1. Attach a protection pad to the image output side of LCD.
CAUTION
Attach the protection pad, matching it to upper line of LCD monitor.
Step2. Out of 4 hooks on the LCD holder, push one side (either side is fine), pressing the
other 2 hooks to the LCD monitor.
Rev. A
Chapter4 Disassembly and Assembly
PhotoPC 600
4-26