Epson PhotoPC600 Service Manual page 73

Color still digital camera

Hide thumbs Also See for PhotoPC600:

Table of Contents

SOLDERING CABLES FOR PREVENTION OF RADIATION (ELECTRIC NOISE) BETWEEN CA1

AND CA2 BOARDS (3) (REFER TO FIGURE 4-25)

Step4.

Solder a black cable coming out of back side of CA2 board to the shield GND(No

number) on the CA1 board. At this time, leave the blue cable coming out of the

same soldered point, since it will be connected to SY1 board.

Rev. A

Chapter4 Disassembly and Assembly

PhotoPC 600

4-24

Table of Contents