Table of Contents
Advertisement
INSTALLING COVER JACK AND LCD SW (CON.) (REFER TO FIGURE4-17)
Step4.
Reverse the rear cabinet so that you can see back of the cabinet and install the
slide monitor for fixing the LCD SW.
CAUTION
Slide Monitor has a determined direction to be attached. Refer to
figure4-17 and push in the LCD SW so that peaking point comes right
side.
INSTALLING THE COVER GRIP BACK (REFER TO FIGURE4-18)
Step5.
Put the FPC cable coming out of the control panel through the hole(A) as you can
see in the figure 4-18.
Step6.
Peel the sticker of the back of control panel unit and attach it to the cover grip back.
CAUTION
n n n n When attaching the control panel unit, be careful not to dislocate it.
n n n n Do not fold the FPC coming out of the control panel unit.
Step7.
Install the strap holder to the cover grip back.
Step8.
Fix the stand under the cover grip back temporally.
CAUTION
The stand has a determined direction to be attached. If the stand is not
fixed correctly at Step8, rotate its direction 180 degree.
Step9.
Fix the cover grip back to the rear cabinet with 2 screws 2x5(#100).
Rev. A
Chapter4 Disassembly and Assembly
PhotoPC 600
4-16
Advertisement
Table of Contents
