Table of Contents
Advertisement
SETTINGS
1.
To change some display settings, select "SETTINGS" from the main menu using buttons
2.
Confirm by pressing
acoustic signal, display brightness, time, energy saving function).
3.
Select the setting you wish to change using buttons
4.
Press button
to confirm.
5.
Follow the instructions of the display to change the settings.
6.
Press button
; a message appears on the display confirming your selection.
N.B.: When the oven is switched off, if the ECOMODE (Energy saving) function is selected (ON), the display
switches off after a few seconds, showing the clock. To view information on the display and switch the light
on again, just press any of the buttons or turn one of the knobs. During a cooking function if the ECOMODE
is activated the cavity lamp will be switched off after 1 minute of cooking and reactivated for each user
interaction. If, on the other hand, the function is not selected (OFF), after a few minutes the display is merely
dimmed.
KEY-LOCK
This function can be used to lock the control panel buttons.
To activate it, press
buttons are locked and the display shows a message and the symbol
during cooking. To deactivate it, repeat the above procedure. When the key-lock function is activated, the
oven can be switched off using button
STARCLEAN™ CLEANING CYCLE
To keep the oven in best condition, carry out the STARCLEAN™ cleaning cycle after each use. The cycle
takes 35 minutes, including a cooling stage, and must be carried out as follows:
For the description of this function, see the chapter CLEANING and the functions table on page 14.
1.
Proceed with oven cold.
2.
Wet the cellulose cloth provided under running water and wring it out so that it does not drip.
3.
Open the oven door and remove the enamelled accessories.
4.
Cover the bottom of the oven completely with the cellulose cloth.
5.
Distribute 350 ml of water evenly on the cellulose cloth. A smaller or greater amount of water could
compromise proper functioning of the cycle.
6.
Close the oven door.
To start the oven cleaning cycle, proceed as follows:
1.
Select STARCLEAN™ from the main menu with the buttons
Starclean
35 minutes water cleaning
2.
Press button
, the display shows:
1/1
Insert the cloth
✓
& press
3.
Press button
: the help message appears, press button
IMPORTANT: To prevent steam coming out, do not open the door during the cycle.
00:00
TIME
Cleaning
15:00
END TIME
4.
At the end of the cycle, remove the cellulose cloth and eliminate any residual water in the oven.
5.
Then start cleaning using a sponge, moistened with hot water (cleaning could be compromised if
delayed by more than 15 minutes).
Particularly stubborn grime
To eliminate particularly stubborn grime, repeat the STARCLEAN™ cycle and add a few drops of neutral
detergent while removing the grime.
: the display shows which settings can be changed (language, volume of
and
at the same time for at least 3 seconds. If activated, the functions of the
.
02:59
TIME
Cleaning
15:00
END TIME
.
. This function can also be activated
and
to confirm and the cleaning cycle starts.
EN13
.
.
Advertisement
Table of Contents
