Battery Compartment; Display Unit Setup; Install Or Replace Batteries; Back Of Display Unit - AcuRite 06005RM Instruction Manual

Display Unit Setup

1
Set the A-B-C Switch
The A-B-C switch is located inside the
battery compartment. It can be set to
A, B or C. However, you must select
the same letter choices for both the
sensor and the display unit in order
for the units to synchronize.
2

Install or Replace Batteries

Insert 3 x AA alkaline batteries into
the battery compartment, as shown.
Follow the polarity (+/-) diagram in
the battery compartment.
PLEASE DISPOSE OF OLD OR DEFECTIVE BATTERIES IN
AN ENVIRONMENTALLY SAFE WAY AND IN ACCOR-
DANCE WITH YOUR LOCAL LAWS AND REGULATIONS.
BATTERY SAFETY: Clean the battery contacts and also those of the device prior to battery installation. Remove
batteries from equipment which is not to be used for an extended period of time. Follow the polarity (+/-)
diagram in the battery compartment. Promptly remove dead batteries from the device. Dispose of used
batteries properly. Only batteries of the same or equivalent type as recommended are to be used. DO NOT
incinerate used batteries. DO NOT dispose of batteries in fire, as batteries may explode or leak. DO NOT mix
old and new batteries or types of batteries (alkaline/standard). DO NOT use rechargeable batteries. DO NOT
recharge non-rechargeable batteries. DO NOT short-circuit the supply terminals.

BACK OF DISPLAY UNIT

1. A-B-C Switch
ID code that must match 5-in-1
sensor's A-B-C switch to ensure
units synchronize.
2. Clear Today
Clears data recorded since
1
12:00am.
2
3. Reset
3
Full reset to factory defaults.
4
4. Clear All
5
Clears all data recorded without
having to reset time and date.

5. Battery Compartment

6. Battery Compartment Cover
(Not shown.)
1
A-B-C Switch
set to match
sensor
2
4
A B C

Install Batteries

3 AA Batteries