Bosch SHU43E Use And Care Manual page 37

Dishwasher
Table of Contents

Advertisement

Figure 30/Ilus. 30
Figure 31/Ilus. 31
A
Figure 32/Ilus. 32
Figure 33/Ilus. 33
36
A
Operation | Fonctionnement | Funcionamiento
(Care and Cleaning, Continued)
2. Firmly press the Large Object Trap/Fine
Filter Assembly into position.
3. Turn the ring handle clockwise 1/4 turn
until it is locked. The arrow on the ring
handle and the arrow on the Fine Filter
should point to each other, as shown in the
circle labelled A in Figure 30.
4. Gently pull the ring handle to ensure that
the Assembly is locked into place.
Check/Clean the Spray Arms
Occasionally check the spray arms to
ensure that the spray nozzles are clear and
unobstructed. If the nozzles require
cleaning, the spray arms are easy to remove
and reinstall.
To remove the lower spray arm:
1. Pull the empty lower rack out of the
dishwasher tub.
2. Grasp the lower spray arm and gently pull
it upward, as shown in Figure 31.
If the spray nozzles need cleaning, flush
them under running water.
To reinstall the lower spray arm:
1. Gently press the lower spray arm back
into its installed position.
To remove the upper spray arm:
1. Remove the empty upper rack from the
dishwasher. The procedure for removing the
upper rack is on page 20 of this manual.
2. Turn the rack upside-down. The upper
spray arm is held in position by a locking nut,
as shown in Figure 32A. Turn the locking nut
counter-clockwise 1/8 turn and remove it, as
shown in Figure 32B, to release the spray
arm.
3. Gently remove the spray arm, as shown
in Figure 33. If the spray nozzles need
cleaning, flush them under running water.
B
To reinstall the upper spray arm:
1. Gently press the upper spray arm back
into its installed position.
2. Return the locking nut to its installed
position and turn it 1/8 turn clockwise.
3. Return the upper rack to the upper rack
roller guides.
Check/Clean the Stainless Steel
Inner Door and Tub
Clean the outer edges of the inside door
panel regularly to remove food particles that
collect there from normal loading. If spots
begin to appear on the stainless steel tub or
inner door, make sure the rinse agent
reservoir is full.
(Continued on Next Page)
E n g l i s h

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Shu53eShu66e

Table of Contents