When Paper Misfeeds; Misfeed Location Indicators; Cautions; Removal Procedures - Kyocera Mita KM-2030 Instruction Handbook Manual

CHAPTER 8 WHEN A PROBLEM OCCURS

2. When paper misfeeds

If a paper misfeed occurs, copying will stop. A misfeed message will appear and the misfeed location will be indicated on the message display.
Remove the misfed paper by referring to "(3) Removal procedures" with the main switch turned ON (|).

(1) Misfeed location indicators

1 Misfeed in paper feed section
2 Misfeed in left cover (page 8-5)
3 Misfeed in DF <optional> (page 8-6)
4 Misfeed in duplex unit <optional> (page 8-6)
5 Misfeed in finisher <optional> (page 8-6)

(2) Cautions

WARNING
High voltage is present in the charger section. Take
sufficient care when working in this area, as there is a
danger of electrical shock.
CAUTION
The copier's fixing unit is extremely hot. Take sufficient
care when working in this area, as there is a danger of
getting burned.
* Do not reuse misfed paper.
* If paper is torn during removal, be sure to remove all loose scraps
from inside the copier, or they could cause misfeed later.
* After misfed paper has been removed, warm-up will begin. The
Misfeed indicator will turn off and the copier will return to the same
settings prior to the misfeed.
8-3

(3) Removal procedures

1 Misfeed in paper feed section 1 1 1 1
Misfeed in drawer
If the message "MISFEED IN PAPER DRAWER. REMOVE PAPER."
appears with the misfeed location indicator shown in the illustration, a
misfeed has occurred in the drawer (or optional drawer). Remove the
misfed paper using the procedure given below.
1
Open the drawer.