How To Set Originals On The Platen - Kyocera Mita KM-2030 Instruction Handbook Manual

2
Set the originals on the original table in correct sequence
with the side to be copied facing upward. Securely insert the
leading edge of the originals into the DF as far as they will
go.
IMPORTANT
• Do not set originals exceeding the limit indicated on the sticker
attached on the rear original insertion guide. Setting more originals
than specified may cause original misfeed.
5 5

5 How to set originals on the platen

5 5
When using an original that cannot be set in the DF, such as a book
or magazine, open the DF and place it on the platen.
1
Hold the DF open/close handle and open the DF.
* Before opening the DF, check that no original is present on
the original table or original eject cover. If present, the
original may fall off when the DF is opened.
CHAPTER 7 OPTIONAL EQUIPMENT
2
Set the original with the side to be copied facing downward.
Be sure to align the original with the original size scales.
3
Hold the DF open/close handle and close the DF.
IMPORTANT
• Do not press the DF against the platen with force. Doing so may
cause damage to the glass material.
CAUTION
DO NOT leave the document feeder open as there is a
danger of personal injury.
7-2