Maintenance - iRobot Robot Owner's Manual

Maintenance

To keep Dirt Dog running at peak performance, it is recommended that you
perform the following maintenance tasks every three uses:
Remove and empty
1
Dirt Dog's bin
Press button and
pull to remove bin
Clean Dirt Dog's cliff detect

sensors (use compressed air)
Sensors
TIP: Bin emptying and brush cleaning should be done after every 3- cleaning
cycles depending on the amount of hair, dirt, and debris in your environment.
TIP: If you notice Dirt Dog picking up less debris from your floor, empty the bin
and clean the brushes.
Excessive build up of hair in Dirt Dog's brushes and bearings can
permanently damage Dirt Dog. Inspect brush bearings regularly.
Do not attempt to run Dirt Dog without the bearings. If you misplace Dirt
Dog's brush bearings, contact iRobot Customer Care for replacement
bearings.
Clean Dirt Dog's brushes
3
A. Remove brush guard by pulling
B. Remove and clean Dirt Dog's
Brushes
Sensors
C. Remove and clean hair and dirt from
both yellow tabs
brushes. Remove brush caps and
use scissors to cut any hair wrapped
around the brush. Use the Dirt Dog
cleaning tool to comb hair from brush.
Brush
caps
Dirt Dog's brush bearings.
Visit www.irobot.com/usetips
for instructional photos
www.irobot.com
Brush
bearings
1