Connect The System To Power - Bose LIFESTYLE DVD Installation Manual

BASIC SYSTEM CONNECTIONS
9 Connect the system to power
Figure 13
Power connection for
the Acoustimass module
Figure 14
Power connection for the
media center power supply
To complete this step, you need the two identical AC power cords, one for the Acoustimass®
module and the other for the power supply.
To connect
power
to
the Acoustimass module:
On the connector panel of the Acoustimass module, plug the appropriate end of one
AC power cord into the AC power jack (Figure 13). Insert the other end of the power cord into
an AC (mains) outlet.
AC power jack
AC power cord
Note: Bose recommends using
a
high-quality surge suppressor on al/ electronics equipment.
Voltage variations and spikes can damage electronic components in any system and the resulting
damage may not be covered by the limited warranty. A quality suppressor can eliminate the vast
majority of failures attributed to surges and may be purchased at electronics stores.
To connect
power
to
the power supply:
Plug the appropriate end of the AC power cord into power supply (Figure 13). Insert the other
end of the power cord into an AC (mains) outlet.
AC (mains)
outlet
~-----------~To the
.......... ...... media center
Power supply
AC Power cord
Voltage selection switch location
(dual-voltage units only)
If you have
a
dual-voltage power supply:
Before connecting power to the media center power supply, MAKE SURE the voltage selec-
tion switch on the bottom of the media center power supply matches the local power rating
(Figure 14). Check with local electrical authorities if you are not sure of the appropriate power
rating.
21