Utility Bed - Cushman LSV 800 Owner's Manual

48 v electric powered low-speed vehicle
Hide thumbs Also See for LSV 800:
Table of Contents

Advertisement

INTRODUCTION
Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers.
The Run/Tow switch should always be returned to the 'RUN' position after moving a stalled vehicle. If the switch is left in the
'TOW' position for an extended period of time, it will drain the batteries.
The Run/Tow switch is located under the seat on the passenger side of the vehicle.
With the switch in the 'TOW' position and the key in 'N':
3
the electronic parking brake is deactivated, which allows a stalled vehicle to be moved or roll freely, except in
the event of a controller failure
the brake is still active
the reverse warning beeper is deactivated
With the switch in 'RUN' position:
the electronic parking brake is activated and the reverse warning beeper features are activated

28. Utility Bed

The manual lift bed is the standard bed for the vehicle.
To reduce the possibility of severe injury or death, read, understand and follow the Danger label
affixed to the front of the utility bed.
Never fill a gas can in the bed of a vehicle. Static discharge could ignite gasoline vapor and
cause an explosion.
A utility bed warning label is affixed to the front of the bed. For safe operation of the vehicle, this label must be under-
stood.See the utility bed warning label for maximum load.The load must be positioned in the bed as far forward as
possible, distributed in such a way that its center of gravity must not be higher than height noted on label, and
secured. Failure to follow these instructions may result in severe injury, damage the vehicle and/or cause the vehicle
to tip over. Use extra care when operating loaded vehicle. Do not permit anyone to ride in the bed. Do not drive the
vehicle with the utility bed raised or with the tailgate unsupported. When using a utility bed, be sure to avoid backing
up to the edge of a drop off, such as a loading dock or ravine. A misjudgment of distance or an unstable surface
could result in the vehicle falling backwards. Always place a gas can on the ground before filling. Never fill a gas can
in the bed of the vehicle. Static electricity is built up during the fueling process and could discharge causing the gas-
oline vapor to ignite.
3 - 8
MAX
300 lbs.
136 kg
MAX
4 in.
P
10 cm
MAX
MAX
14
/ 25%
o
100 lbs.
45 kg
74821G07

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

2012 lsv 800

Table of Contents