Information Messages - Sony SRX-R220 Operating Instructions Manual

Message number Error message
WARN_22 DEVICE ERROR
WARN_23 CONNECTOR DETACHED
WARN_24 CONNECTOR DETACHED
WARN_25 CONNECTOR DETACHED
WARN_26 DOUSER ERROR
WARN_27 BALLAST ERROR
WARN_28 BALLAST ERROR
FAILURE: Danger level – Low
Message number Error message
FAIL_01 TEMPERATURE ERROR
FAIL_02 TEMPERATURE ERROR
FAIL_03 TEMPERATURE ERROR
FAIL_04 TEMPERATURE ERROR
FAIL_06 TEMPERATURE ERROR
FAIL_10 TEMPERATURE ERROR
FAIL_11 TEMPERATURE ERROR
FAIL_12 TEMPERATURE ERROR
FAIL_13 TEMPERATURE ERROR
FAIL_15 TEMPERATURE ERROR
FAIL_16 LENS ERROR
FAIL_17 LENS ERROR
FAIL_18 LENS ERROR
FAIL_19 LENS ERROR
FAIL_21 ADJUSTMENT ERROR
FAIL_24 ADJUSTMENT ERROR
FAIL_25 DEVICE ERROR
FAIL_26 DEVICE ERROR
FAIL_27 DEVICE ERROR
FAIL_28 DEVICE ERROR
FAIL_29 DEVICE ERROR
FAIL_30 BALLAST ERROR
FAIL_34 ADJUSTMENT ERROR
FAIL_35 ADJUSTMENT ERROR
FAIL_36 DEVICE ERROR

Information Messages

The message number is not displayed for information messages. Check the following if a message appears in the STATUS
MESSAGE window.
Message
DOUSER CLOSED
LAMP POWER + LIMIT
24
Messages
Meaning
Failure of the peltier B control
The peltier R connector disconnected
The peltier G connector disconnected
The peltier B connector disconnected
Trouble with the douser operation
Failure of the ballast communication for the lamp power
Incorrect settings of the lamp S/N or the lamp power wattage
Meaning
Temperature of the system area is too high.
Temperature of the projector head area is too high.
Temperature of the power area is too high.
Temperature of the intakes is too high.
Temperature of the optical unit area is too high.
Warning for abnormal temperature of Panel R
Warning for abnormal temperature of Panel G
Warning for abnormal temperature of Panel B
Warning for abnormal temperature of the lamp
Warning for abnormal temperature of the lamp power
Failure of the zoom position adjustment to the registered setting
Failure of the lens focus adjustment to the registered setting
Trouble with the zoom position adjustment
Trouble with the lens focus adjustment
Abnormal in the Z-axis adjustment
Failure of calibration for luminance deterioration
Failure of FPGA configuration
Trouble with the IIC circuit
Trouble with the LVDS circuit
Trouble with the PLL circuit
Trouble with the PARITY circuit
Lamp power interlocked
Deviation of the Z-axis operation for + direction
Deviation of the Z-axis operation for – direction
Error of the DVI setting
Meaning
Douser is closed.
Lamp power was automatically adjusted by correcting luminance
deterioration, but the picture is not brighter.