Sony SRX-R220 Operating Instructions Manual page 21

Rear
a STATUS MESSAGE window
Displays various messages.
For details on the messages, see page 22.
b Status indicators
Combinations of the MAIN and LAMP indicators indicate
the status of the projector as follows:
MAIN LAMP Status of the projector
indicator indicator
– z (in red) The LAMP switch is turned on and the
unit is in standby mode.
z (in red) – The MAIN switch is turned on and the
unit is in standby mode.
z (in red) z (in red) The unit is in standby mode. You can
turn on the unit with the controller.
z z (in green) The unit is turned on with the
(in green) controller. You can operate the unit
with the controller.
The unit is in standby after shutting it
down with the controller. Cooling fans
(in green) (in green)
are running.
z
The unit is in lamp-off mode.
(in green)
(in green)
z: Lights : Flashes –: Goes out
c Lamp adjustment window
The lamp adjustment screw is inside this window. Fine
adjustment of the lamp position is necessary after
replacing the lamp.
For adjustment, contact Qualified Sony Service Personnel.
1
2
3
4
5
6
7
8
d Ventilation holes (intake) (rear)
e MAIN switch
Turns on/off the main switch.
To turn off the projector completely
The projector is ready to be turned off when the LAMP
indicator flashes in green then lights in red steadily. You
can then turn off the MAIN switch to turn off the projector
completely.
You can turn on the projector in any order.
For more information, refer to the Installation Manual
(not supplied).
f LAMP switch
Turn on/off the lamp switch.
g INGEST PORT connector
Connects a removable drive to ingest the digital cinema
contents.
Note
If you use this connector, you must make the necessary
connections with this connector inside the projector
housing referring to the Installation Manual when the
projector is installed.
For details, refer to the Installation Manual (not supplied).
h RS-232C connector
Connects the SRX controller. This is for service use.
Location and Function of Controls
21