Table of Contents
Advertisement
~
VM9512HD
Optional Equipment
NAV101
The VM9512HD is "navigation ready." Before accessing
any navigation features, you must purchase and install
the NAV101 module. All installation and operating
instructions will be included with the NAV101 navigation
module.
Once the NAV101 is connected and operating properly,
the NAV source mode will become active. While the
NAV101 is not installed, the NAV option appears gray,
indicating the function is not available.
Rear Camera
The VM9512HD is "camera ready." Before accessing
any camera features, you must purchase and install a
rear video camera. Once the rear camera is connected
and operating properly, the CAMERA source mode will
become active. While the camera is not installed, the
CAMERA option appears gray, indicating the function is
not available.
Satellite Radio Tuner
See "Satellite Radio Operation" on page 22.
iPod
See "MP3/\/IIMA Operation" on page 28.
Bluetooth Phone
See "Bluetooth Operation" on page 32.
What's in the Box
1.
Cosmetic trim ring
2.
Wiring harness power/speaker
3.
Mounting hardware for VM9512HD
4.
Single DIN sleeve
5.
HD Radio Module
6.
HD Radio Module connecting DIN cable
7.
Remote Control
8.
Parking brake sensor extension wire
9.
Media Link Module
10. Mounting hardware for HD Radio Module
11 . Owners Manual
12. Quick Start Guide
Tools and Supplies
You will need these tools and supplies to install your
VM9512HD:
Torx type, flat-head and Philips screwdrivers
Wire cutters and strippers
Tools to remove existing radio (screwdriver, socket
wrench set or other tools)
Electrical tape
Crimping tool
Volt meterltest light
Crimp connections
18 gauge wire for power connections
16 - 18 gauge speaker wire
Disconnecting the Battery
To prevent a short circuit, be sure to turn off the ignition and
remove the negative (-) battery cable prior to installation.
NOTE: If the VM9512HD is to be installed in
a
car
equipped with an on-board drive or navigation computer,
do not disconnect the battery cable. If the cable is
disconnected, the computer memory may be lost Under
these conditions, use extra caution dUring Installation to
avoid causing
a
short circuit
2
WARNING! Only connect the unit to
a
12-volt power
supply with proper grounding.
WARNING! Never install this unit where operation and
viewing could interfere with safe driving conditions.
WARNING! To reduce the risk of a traffic accident (except
when using for rear view video camera) never use the
video display function while driving the vehicle. This is
a
violation of federal law.
WARNING! Never disassemble
or
adjust the unit.
WARNING!
To
prevent injury from shock
or
fire, never
expose this unit to moisture
or
water.
WARNING! Never use irregular discs.
WARNING!
To
prevent damage to the mechanism inside
this unit, avoid impact to the TFT monitor.
WARNING! Using
an
improper fuse may cause damage
to the unit and result In
a
fire.
WARNING! The monitor employs
an
automatic motorized
mechanism. To prevent damage to the core mechanism,
please do not pUSh, pUll
or
swivel the monitor manually,
other than in the manner explained in "Monitor Left/Right
Angle Adjustment" on page 12.
Advertisement
Table of Contents
