Jensen VM9512HD Installation And Operation Manual page 16

VM9512HD
~
Parameter Adjustment Procedure
1. Enter Picture Quality Setting Mode:
Press the PIC button (24) on the remote control or press
and hold the WIDE/PICTURE button (22) on the moni-
tor.
2. Select Item to Set:
Use the up/down joystick buttons to select "BRIGHT" or
"CONTRAST'.
3. Set Parameters:
Use the lefllright joystick buttons to modify the settings.
4. Exit Picture Quality Setting Mode:
Press the PIC button on the remote control or the WIDE/
PICTURE button on the monitor
Parking Brake Inhibit
When the pink "Parking" wire is connected to the vehicle
Parking Brake circuit, the front TFT monitor will display video
when the Parking Brake is engaged. (When the pink wire is
grounded via the Parking Brake circuit, video will be
displayed.)
Monitor Movement Mechanism
If an obstruction occurs in the monitor path, the following
protective measurements can be executed to prevent
damage to the mechanism or monitor:
Table 3: Monitor Protective Measures
Obstruction
Self OPEN Button
Power
Protection
Pressed Reconnected
Monitor load- Unit stops at Monitor fully Monitor is auto-
ing out hori- obstruction extended hori- matically
zontally point zontally loaded into un~
Monitor load- Unit stops at Mon~or
fully
Monitor is auto-
ing in hori- obstruction extended hori- matically
zontally point zontally loaded into un~
Mon~or load- Un~
stops at
Mon~or
swiv- Monitor swiv-
ing out verti- obstruction
els back to the els back to the
cally point un~ unit
Mon~or
load-
Un~
stops at Monitor swiv- Monitor swiv-
ing in verti-
obstruction els back to the els back to the
cally point un~ unit
After the protective procedure is executed, normal operation
is resumed by pressing the OPEN button (1) or disconnecting
and reconnecting the power.
13