NETGEAR GA 620 Reference Manual page 47

GA620/620T.Manual.R2 6/12/00 1:55 PM Page 49
5. Edit the AUTOEXEC.NCF file and modify card load parameters.The card
parameters that can be defined in the load statements are described in Table 5-3
on page 5-6.
For example: A valid AUTOEXEC.NCF file is shown below. One set of load and
bind commands (in bold) is added for each type of frame the card is configured
to support:
set Time Zone = PST8PDT
set Daylight Savings Time Offset = 1:00:00
set Start Of Daylight Savings Time = (APRIL SUNDAY FIRST 2:00:00 AM)
set End Of Daylight Savings Time = (OCTOBER SUNDAY LAST 2:00:00 AM)
set Default Time Server Type = SINGLE
# Note: The Time zone information mentioned above
# should always precede the SERVER name.
set Bindery Context = O=NETGEAR
file server name MARS
ipx internal net 34881EEE
load conlog maximum=100
; Network driver LOADs and BINDs are initiated via
; INITSYS.NCF. The actual LOAD and BIND commands
; are contained in INITSYS.NCF and NETINFO.CFG.
; These files are in SYS:ETC.
sys:etc\initsys.ncf
load GA620 slot=4 frame=Ethernet_802.2 name=alt_1_e82_2
bind ipx alt_1_e82_2 net=aaaa
mount all
set immediate purge of deleted files = on
set upgrade low priority threads = on
set display spurious interrupt alerts = on
set display lost interrupt alerts = on
netware driver software 5-5