Changing Configuration Parameters - NETGEAR GA 620 Reference Manual

Gigabit ethernet cards

Hide thumbs Also See for GA 620:

Table of Contents

GA620/620T.Manual.R2

6/12/00

5. In the Driver Files Search Results window, verify that the correct path to

the driver software is shown, then click the Next button.

Once installation of the driver software has been completed, you are ready to

configure card properties. For the procedure, see the section,"Modifying

Configuration Parameters."

Changing Configuration Parameters

Although the default values should be appropriate in most cases, you may change any

of the available options to meet the requirements of your specific system. Once the

Gigabit Ethernet card driver software has been installed, you can use this procedure

to verify or change the following properties:

• Link Negotiation

• Network Address

• Rx flow control

• Tx flow control

windows 2000 driver software

1:55 PM

Page 40

4-4

Table of Contents