NETGEAR GA 620 Reference Manual page 20

GA620/620T.Manual.R2 6/12/00
Connect one end of the cable to the Model GA620 Gigabit Ethernet Card, as shown
in Figure 2-3.
Figure 2-3. Fiber Connector for the Model GA620 Gigabit Ethernet Card
3. Connect the other end of the cable to a Gigabit Ethernet network port.
Attach the cable connector so that the Tx port on the Model GA620 Gigabit
Ethernet Card is connected to the Rx port of the device at the other end of
the cable.
4. Turn on power to the PC and then to the connected device.
5. Verify that the Link LED is on (on the Model GA620 Gigabit Ethernet Card),
indicating that there is a good link on the port.
If the Link LED is off, it could indicate a bad cable, a bad cable connector, or a
configuration mismatch. For more information about troubleshooting your prob-
lem, refer to Chapter 6 "Troubleshooting," before installing a driver as outlined in
Chapter 3 "Windows NT Driver Software," Chapter 4 "Windows 2000 Driver
Software," or Chapter 5 "Novell NetWare Driver Software."
1:55 PM Page 21
Warning: Fiber optic equipment can emit laser or infrared light that might injure your
eyes. Never look into an optical fiber or connector port. Always assume that fiber optic
cables are connected to a light source.
003FA
hardware installation 2-9