Denon AVR-1803 Operating Instructions Manual page 44

Select the DTS NEO:6 mode.
- CENTER IMAGE setting
' (Mm mt) Wemote control wtl
l
The mode switches as shown below each time the button
is pressed.
DOLBY PLII cinema
P
+
DTS NEO:6
3
Play a program source
4 Select the surround parameter mode.
S"RRO"ND
S"RRO"ND
Drsplay
PARAMETER PARAMETER
y c F/ i:::
, . . ..!d ! ,.,.
:.... i :_.._ ::::: :.:.: ::::
.,,. E i. . . . . . : .,..:
(Mm mt) (Remote control unlti
% To perform this operation from the remote control unit,
check that the mode selector switch is set to "AUDIO".
Select the optimum mode for the source.
5 (0) fj &
(Mm mtl
wmlote control un1tj
6 Set the surround parameters according to the mode
SURRCWND
SURROUND
PARAMETER
PAFtAMETER
(Mm unltj
(Remote control unit)
l
The mode switches as shown below each time the button
is pressed.
7 Set the various surround parameters
l
CINEMA EQ setting
l
DEFAULT setting
+X Select "Yes" to reset to the factory defaults
8
Press the ENTER button to finish surround parameter mode.
(Remote control unit)
Surround parameters 0
Pro Logic II Mode:
The Cinema mode is for use with stereo television shows and all
programs encoded Dolby Surround.
The Music mode is recommended as the standard mode for
autosound music systems (no video), and is optional for A/V
systems.
The Pro Logic Emulation mode offers the same robust surround
processing as original Pro Logrc in case the source contents is not
of optimum quality.
Select one of the modes ("cinema", "music" or "emulation").
Panorama Control:
This mode extends the front stereo image to include the
surround speakers for an excittng "wraparound" effect with
side wall imaging.
Select "OFF" or "ON".
Dimension Control:
This control gradually adjust the soundfield either towards the
front or towards the rear.
The control can be set in 7 steps from 0 to 6.
Center Width Control:
This control adjust the center image so it may be heard only
from the center speaker; only from the left/right speakers as a
phantom image; or from all three front speakers to varying
degrees.
The control can be set in 8 steps from 0 to 7.
DTS NEO:6 MUSIC:
CENTER IMAGE (0.0 to 0.5: default 0.2)
The center image parameter for adjusting the expansion of the
center channel in the DTS NEO:6 MUSIC mode has been added.
44