Denon AVR-1803 Operating Instructions Manual page 26

For the three kinds of input signals as shown below, the surround mode played the last is stored in the memory. At next time It the same signal
inputs, the memorized surround mode is automatically selected and the signal is played.
Note that the surround mode setting is also stored separately for the different input function.
I
1 SIGNAL 1 Default Auto Surround Mode 1
@ Analog and PCM Z-channel signals STEREO
0
2-channel signals of Dolby Digital, DTS or other multrchannel format Dolby PLII Cinema
0
Multichannel signals of Dolby Digital, DTS or other multichannel format Dolby or DTS Surround
1
OI
Use the 0 (left) and 0 fright) buttons to select the Auto Surround mode
4 b (Inrtial)
,: ,..., . . . . :
: '...'
.i. :...:
i ,,,: : j "F i-: ::::' j i I:-:: I:-::
; i:,,,: i :,,,/ ,,,, :: ,.,.: .,: ., ::
j"'; 1.. j
pjq rq
.,,,: j '/
cl-- -0
(left) button
(rrght) button
Press the ENTER or a (down) button to switch the Ext. In SW Level settrng.
Set the playback level of the analog input signal connected to the Ext. In terminal.
1
o&Y
Use the 0 (left) and 0 (right) buttons to select the Ext. In Subwoofer channel Level playback.
4 b
(Initial)
(left) button (right) button
Press the ENTER or a (down) button if you want to start the settings over from the beginnrng
l
Select according to the specificatrons of the player being used. Also refer to the player's operating instructrons
l
+15dB (default) recommended. (0, +5, 10 and +I 5 can be selected.)
Press the SYSTEM SETUP button to finish system set up.
This completes the system setup operations. Once the system IS set up, there is no need to make the settrngs agarn unless other components
or speakers are connected to or the speaker layout is changed.
26