Denon AVR-1803 Operating Instructions Manual page 32

12 OPERATION
III
1 Refer to "CONNECTIONS" (pages 9 to 17) and check that all
connections are correct.
2
Set the remote control unit's slide
AUDIO.
switch to the AUDIO position. (only
when operating with the remote
m
. VIDEO -
control unit)
A
3 Turn on the power.
Press the ON/STANDBY button on the main untt or
ON/SOURCE button on the remote control unit to turn on the
power.
(Mm unltl
(Remote control unltl
. ON/STANDBY
When the button is pressed, the power turns on and the
display lights after approximately 1 second.
When pressed again, the power turns off, the standby
mode is set and the display turns off.
Several seconds are required from the time the power
operation switch is set to the "ON" position until sound is
output. This is due to the built-in muting circuit that
prevents noise when the power switch is turned on and off.
32