Denon AVR-1803 Operating Instructions Manual page 34

3
Select the play mode.
Press the SURROUND MODE button, then turn the SELECT
knob.
Example: Stereo
(Mann unItI (Remote control unlti
.% To select the surround mode while
SVRRO"NDMODE
adjusting the surround parameters,
channel volume or tone control,
press the surround mode button
then operate the selector.
(Main un~tl
4 Start playback on the selected component.
l
For operating instructions, refer to the component's
manual.
The volume level IS
dlsplayed on the
master volume level
display.
% The volume can be adjusted within the range of -70 to 0
to 18 dB, in steps of 1 dB. However, when the channel
level is set as described on page 41, if the volume for any
channel is set at +I dB or greater, the volume cannot be
adjusted up to 18 dB. (In this case the maximum volume
is adjusted to "18 dB - (Maximum value of channel
level)".)
Input mode when playing DTS sources
l
Noise will be output if DTS-compatible CDs or LDs are played In the
"ANALOG" or "PCM" mode.
When playing DTS-compatible sources, be sure to connect the
source component to the digital input jacks (OPTICAL/COAXIAL)
and set the input mode to "DTS".
Input mode display
l
In the AUTO mode
lNP"T ~~~ -
aup PCM DE
;g
0 0
l
In the DIGITAL PCM mode
~ lNP"T ---~
AUTO DTS
0
28
0
0 In the DIGITAL DTS mode
INP",
4"TO PCM
0 0
g
One of these Ilghts, depending on the
Input SIgnal
m /zixq
pici%iq
PALI
l
In the ANALOG mode
~ lNPUT - ~_
AUTO PCM DTS
0 0 0
Input signal display
l
DOLBY DIGITAL
.% The -1 Indicator lights when dlgital signals are being Input
properly. If the -1 Indicator does not light, check whether
the digital input component setup (page 24) and connections are
correct and whether the component's power is turned on
NOTE:
l
The 11 Indicator WIII light when playing CD-ROMs
containing data other than audio signals, but no sound wtll be
heard.
34