Sony MSW-A2000 Operation Manual page 14

2-1 Control Panels
1 Audio control section
1 Audio selection function selector buttons
2 DISPLAY FULL/FINE button
3 Audio setting display section
6 PB controls
5 REC controls
In the audio control section, you can select and display
input and output signals for audio channels 1 to 8.
Depending on the number of audio recording channels,
the indication of the format during tape playback
changes to an indication of the channels that can be
set.
Switching audio recording mode between 16-bit/8-channel
and 24-bit/4-channel requires maintenance menu
operations. For details, refer to the Maintenance Manual
Volume 1.
When a digital Betacam tape is played back, the digital
audio levels are displayed on the level meters for
channels 1 to 4 in the audio setting display section 3.
The level meter for channel 7 displays the cue audio
level always in FULL mode (see the description of the
DISPLAY FULL/FINE button 2).
2-4
Chapter 2 Location and Function of Parts
1 Audio selection function selector buttons
INPUT (input signal selection mode) button:
4 Audio signal
selection buttons
7 ALL CH
indicators
MIXING (mixing setting mode) button: Pressing
On how to operate in input signal selection mode, mixing
setting mode, and monitor signal selection mode, see the
descriptions of the audio signal selection buttons 4 on page
2-5.
2 DISPLAY FULL/FINE button
Pressing this button toggles the display mode of the
level meters in the audio setting display section
between FULL and FINE.
FULL: The display covers the range –60 dB to 0 dB
FINE: The display is enlarged, with a step of
Pressing this button puts the unit into input signal
selection mode. In the audio setting display
section, indicators flash to indicate the currently
selected signal for each channel (SDI, AES/EBU,
or ANA). In this state, you can use the audio
signal selection buttons to select the signal to
input to each channel.
Pressing this button again takes the unit out of
input signal selection mode and puts it into
monitor signal selection mode.
Note
When SDTI is selected for the input video signal,
you cannot use audio signal selection buttons to
make audio signal input selection for each
channel. Use the function menu to make SDTI
signal selection.
this button puts the unit into mixing setting mode.
In the audio setting display section, the MIX
indicator flashes. In this state, you can use the
audio signal selection buttons to specify which
input channel signal will be recorded on which
audio track on the tape.
Pressing this button again takes the unit out of
mixing setting mode and puts it into monitor
signal selection mode.
or –40 dB to +20 dB as selected using setup menu
item 806. In this mode the segment of the display
corresponding to the current audio level and all
lower segments light.
0.25 dB. A segment indicating the reference level
lights. In this mode only the segment of the
display corresponding to the current audio level
lights. If the audio level exceeds the maximum
display level, the top segment flashes, and if the
audio level goes below the minimum display
level, the bottom segment flashes.