Sony MSW-A2000 Operation Manual page 106

9-2 Setup Menu Operations
Resetting the menu settings to their
factory default values (menu item B20)
To reset the current active menu settings to their
factory default values, proceed as follows.
1
Perform steps 1 to 3 of the procedure described in
the section "To change the settings of menu items
without sub-items" on page 8-3 to set menu item
B20 RESET SETUP to ON.
The current active menu settings are reset to their
factory default settings.
2
Press the F5 (SET) button again.
This saves the menu settings.
Switching between 525-line and 625-line
modes (menu item 013)
To switch between 525-line (NTSC) and 625-line
(PAL) operation modes, proceed as follows.
When shipped the MSW-2000 is set to 625-line mode.
Notes
• Before carrying out this operation, consult the person
responsible for system installation.
• When the MSW-A2000 is used in the 625-line mode
or when the MSW-A2000P is used in 525-line mode,
analog tape can only be played back in the simple
playback mode.
1
Perform steps 1 to 3 of the procedure described in
the section "To change the settings of menu items
without sub-items" on page 9-3 to set menu item
013 525/625 SYSTEM SELECT to ON.
You can now change the selection between 525-
line and 625-line operation modes.
2
Switch the setting, then press the F5 (SET) button.
3
Turn the unit off.
Next time the unit is turned on, it operates in the new
mode.
9-4
Chapter 9 Setup Menus
Menu bank operations (menu items B01 to
B13)
This unit allows menu settings to be saved in what are
termed "menu banks". Saved sets of menu settings can
be recalled for use as required.
To save the current active menu settings
Set one of menu items B11 SAVE BANK 1 to B13
SAVE BANK 3 to ON, depending on which of the
menu banks you wish to save in, then press the F5
(SET) button.
To recall settings from a menu bank
When recalling the settings saved in one of menu
banks 1 to 3, set the corresponding one of menu items
B01 RECALL BANK 1 to B03 RECALL BANK 3 to
ON, then press the F5(SET) button.
When you wish to recall the settings saved in menu
bank 4, select bank-4 with menu item B20 PRESET
SETUP.
For details about menu bank 4, refer to the Maintenance
Manual.
Recall (B01)
Current active
Save (B11)
menu settings
Recall (B02)
Save (B12)
Recall (B03)
Save (B13)
Recall (B20)
a)
Save
a) Use maintenance menu item 122.
The current active setup menu settings as well as
settings saved in menu banks are stored in separate
storage areas for 525-line and 625-line modes.
Save
Menu bank 1
a)
Menu bank 2
a)
Menu bank 3
a)
Menu bank 4